High-pressure automatic tyre inflator - Flatematic High Pressure
- Inflate your high-pressure tyres automatically up to 232 psi/16 bar.
- Wall-mounted unit with 7.6 m air hose to easily reach all tyres on the vehicle.
- Only 2 min. 20 sec. to inflate a 11R22.5 tyre from 0 to 100 psi/6.89 bar.
- Loud audible signal warns that the tyre has reached the desired pressure.
- 4 measurement units (psi, bar, kPa, kg/cm2), nitrogen purge cycles, LCD screen & backlight.
Designed for high-pressure tyres the Flatematic High Pressure automatic tyre inflator can precisely inflate up to 232 psi/16 bar. Once connected to the tyre, this single-outlet automatic tyre inflator will automatically start inflation or deflation. Its clip-on chuck makes tyre inflation more productive by allowing you to work away from the tyre.
The Flatematic High pressure is also nitrogen compatible. It is equipped with a N2 purge cycle function which can perform up to 5 nitrogen-purification cycles during a single inflation. Each cycle will deflate to 5 psi/0.34 bar, then inflate with nitrogen up to the selected pressure. As purge cycles are performed, the nitrogen purity in the tyre increases.
*Air compressor required
*Compatible with MARTINS’ MW-Stand in order to fix on a tyre inflation cageImportant: compressed air contains water and oil, use proper air filter between the source and device. Failure to do so will void the warranty.
|Features||Fixed, Wall-mounted, High-Pressure, Over pressure setting (OPS), Nitrogen compatible (n2)|
|Colour||Black and yellow|
|Air compressor required||Yes|
|Air pressure - max. outlet (psi)||232|
|Air pressure - max. outlet (bar)||16|
|Air pressure - max. inlet (psi)||261|
|Air pressure - max. inlet (bar)||18|
|Reading accuracy (psi)||0.29|
|Reading accuracy (bar)||0.02|
|Airflow - max. (l/min)||2500|
|Airflow - max. (CFM)||92|
|Hose length (cm)||760|
|Autocalibration||Yes, on every unit start|
|Maintenance & calibration service||Yes|
|Degree of protection||IP66|
|Temperature range||-10 °C ~ 50 °C / 14 °F ~ 122°F|
|Product dimensions - LxWxH (cm)||23 x 27 x 9|
|Net weight (kg)||6.3|
|Package dimensions - LxWxH (cm)||31 x 31 x 23|
|Gross weight (kg)||7.7|
|Air inlet thread||1/4'' NPT Female|
Can the inflator be installed outside?
No, the inflator is not intended for prolonged outdoor use. Its Ingress Protection (IP) rating is 66.
Do I need an air compressor with my inflator?
Yes, the inflator does not produce compressed air.
What kind of air compressor should I use with this product?
The compressor should
have a stable air supply monitored by an air regulator (maintain a minimum air pressure fluctuation)
be equipped with an air filter to protect against water and oil contained in compressed air.
meet the minimum and maximum air inlet pressure of the inflator.
Do I need to recalibrate my inflator?
No, the inflator has an automatic calibration feature. It recalibrates itself every time it starts.
Can I use another type of chuck on my inflator?
Yes, other chuck types can be used. However, the chuck type installed on the inflator must be respected. In this case it is an open chuck. The chuck must also remain in place without someone holding. (clip on chuck, screw on chuck, etc.)
What maintenance service do you offer?
MARTINS offers Maintenance and calibration service (MW-MC) in addition to its 1 year warranty.